ASROCK EN2C602-4L/D12 Příručka pro rychlý start stáhnout pdf (Strana 25)

2.5.8 Network Bonding Conguration

This page is used to configure the network bonding configuration for

network interfaces.

NOTE: A minimum of 2 network interfaces are required to enable Network

bonding for the device.

Network Bonding

Check this option to enable network bonding for network interfaces.

NOTE: If VLAN is enabled for slave interfaces, then Bonding cannot be

enabled. VLAN can be disabled under Conguration -> Network -> VLAN.

Default Interfaces

Choose any one of the bonding interfaces for conguring active slave(s).

Auto Conguration

Enable this option to configure the interfaces in service configuration

automatically.

NOTE: If Auto conguration is disabled, then interfaces in services can be

congured via IPMI command. If Auto conguration is enabled, then all the

services will be restarted automatically.

Save

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 58 59

Žádné komentáře

ASROCK EN2C602-4L/D12 Příručka pro rychlý start Strana 25